9: Option Modules; Annunciators/Udact - Honeywell Fire-Lite Alarms MS-9200UDLSE Manual

Programming
PROGRAMMING
1=HISTORY
2=WALKTEST
3=OPTION MODULES
Programming Screen #3
96
3.6.9 Option Modules
Options available for the MS-9200UDLS include ACS Series, Graphic and LCD
annunciators, printer connection for acquiring hardcopy printouts of panel data and PC
(Personal Computer) connection for uploading and downloading panel data.
Pressing 3 while viewing Programming Screen #3 will display the following screen:
OPTION MODULES

1=ANNUNCIATORS/UDACT

2=ONBOARD DACT
3=PRINTER/PC
Note that PR4800 in the display indicates that a supervised printer, configured for 4800
baud, has been previously programmed into the system.
3.6.9.1 Annunciators/UDACT
Pressing 1 while viewing the Options Screen will cause the control panel to display
the following screens:
1=TERM ENABLED
2=ACS ENABLED
3=UDACT
1=ACS INSTALLED
A Terminal Mode annunciator* and ACS Mode annunciator can be installed in the
MS-9200UDLS system. To enable any of these devices, press the number
corresponding to the selected device shown in Annunciator Screen #1 so that Yes
appears in the display to the right of the device. Each press of the corresponding
number key will cause the display to toggle between Enabled Yes and Enabled No.
Notes:
1. *The LCD-80F is a Terminal Mode annunciator. To enable the MS-9200UDLS
for LCD-80F operation, program Term Enabled to Yes.
2. The Terminal Mode annunciator (LCD-80F) and the Printer/PC use the same
TB8 terminal block on the MS-9200UDLS main circuit board. Only one device
can be connected at one time, therefore, programming Term Enabled to Yes will
disable any Printer/PC communications.
PR4800
Options Screen
ANNUNCIATOR
Annunciator Screen #1
ANNUNCIATOR
Annunciator Screen #2
MS-9200UDLS PN 52750:A 11/04/05
Master Programming Level
YES
YES
YES