Installing The Crossrail Supports (Four-Post Rack Only); Assemble The Crossrail Supports - Cisco SCE 2000 4/8xFE Quick Start Manual

Figure 3: Attaching the Mounting Brackets (2-post)
To install the rack-mount brackets on the SCE 2000 chassis, complete the following steps:
Before installing the SCE 2000 in the rack, you must first install a rack-mount bracket on each side of the front of the
SCE 2000.
Step 1 Align the rack-mount bracket to the side of the SCE 2000. Choose the proper bracket for your installation (2-
post rack or 4-post rack) as illustrated in
Step 2 Insert and tighten three screws.
Step 3 Repeat steps 1 and 2 on the other side of the SCE 2000.
If mounting the SCE 2000 in a rack with only two posts, skip to Mounting the System to a Rack.
If mounting the SCE 2000 in a rack with four posts, proceed to the next step to attach the crossrail supports to the rack.

Installing the Crossrail Supports (Four-post rack only)

This section provides information for assembling the crossrail supports and attaching them to the rack.
When mounting in a rack with four posts (front and back) the two crossrail supports are mounted one on each side of the
rack. The SCE 2000 then slides into these crossrails, which support the weight of the unit.

Assemble the Crossrail Supports

Figure 4: Assembling the Slider Brackets
Assemble the two crossrail supports. Use three screws for each crossrail assembly.
Make sure that they are oriented so that both crossrails will support the SCE 2000 when they are attached to the rack.
8
Rack-Mount the SCE 2000 (on page 7).