Table of Contents
Advertisement
Step 10: Completing and Saving the Configuration
When you have completed the entire configuration, the system checks for errors. If errors are found, a warning message
appears. When the configuration is error-free, you may apply and save it.
To complete and save the configuration, complete the following steps:
The system informs you that data collection is complete.
Step 1
We recommend that you view the entire new configuration before it is applied.
Type y and press Enter.
Note that there is no default.
If there are no errors, go to step 3.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]: y
Step 2
If any errors are detected, you may choose to view them.
Press Enter.
Found errors in the new configuration, would you like to view them? [yes]:
The following errors were found:
Warning - RDR formatter destination 10.1.1.1 is not allowed in the IP access-class.
You are asked whether to apply and save the configuration.
Step 3
Apply and Save this configuration? [yes/no]:
To apply and save the configuration, type y and press Enter.
•
To abort the setup procedure without applying or saving the configuration (recommended if there are errors), type
•
n and press Enter.
Setup procedure aborted, no configuration changes made.
If the setup is aborted, the dialog is ended.
If there are no errors, the system requests confirmation of either a yes or no answer, in order to prevent mistakes.
Step 4
Type the appropriate answer (y or n) and press Enter.
The running configuration would be overwritten by the changes you have just entered, are
you sure? [yes/no]:
The selected action is carried out by the system.
•
If the apply and save action is not confirmed (no), the setup is aborted.
Setup procedure aborted, no configuration changes made.
If the apply and save action is confirmed (yes), the configuration is applied and saved.
•
The new running configuration will be saved to the startup configuration.
If the configuration was applied and saved, you may also save it to a file at a remote station.
Step 5
Do you want to save a copy of the startup configuration file in a remote station? [no]:
To save the configuration to a remote station, type y and press Enter.
The system will ask for FTP path:
35
Advertisement
Table of Contents
