Table of Contents
Advertisement
Chapter 2
Rack-Mount the SCE 1000
Figure 2-4
MN G 1
MN G 2
CO NS OL
E
LIN K/
10/ 100 /
AC TIV E
LIN K/
100 0
10/ 100 /
AC TIV E
100 0
To install the rack-mount brackets on the SCE 1000 chassis, complete the following steps:
Before installing the SCE 1000 in the rack, you must first install a rack-mount bracket on each side of
the front of the SCE 1000.
Align the rack-mount bracket to the side of the SCE 1000. Choose the proper bracket for your installation
Step 1
(2-post rack or 4-post rack) as illustrated in
Step 2
Insert and tighten three screws.
Repeat steps 1 and 2 on the other side of the SCE 1000.
Step 3
If mounting the SCE 1000 in a rack with only two posts, skip to
If mounting the SCE 1000 in a rack with four posts, proceed to the next step,
Supports (Four-post rack
Installing the Crossrail Supports (Four-post rack only)
This section provides information for assembling the crossrail supports and attaching them to the rack.
When mounting in a rack with four posts (front and back) the two crossrail supports are mounted one on
each side of the rack. The SCE 1000 then slides into these crossrails, which support the weight of the
unit.
•
•
Assemble the Crossrail Supports
Assemble the two crossrail supports. Use three screws for each crossrail assembly.
Step 1
OL-7822-06
Attaching the Mounting Brackets (2-post)
PW R A
PW R B
ST AT US
BY PA SS
C is c o S
AU X
LIN K RX
TX
LIN K RX
TX
RX
MM
TX
RX
MM
TX
GB E-1
SU B
LIN E
NE T
only).
Assemble the Crossrail Supports
Attach the Crossrail Supports to the Rack
Installing the Crossrail Supports (Four-post rack only)
C E 1 0 0 0
S er ie s
2 x G B E
Rack-Mount the SCE 1000
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
1
2
Mount the System to the
Rack.
Installing the Crossrail
2-3
Advertisement
Table of Contents
