Table of Contents
Advertisement
To permit access press Enter.
•
To deny access type n and press Enter.
•
Does this entry permit access? [yes]:
Step 5
Type the IP address to be added to this list, and press Enter.
Type "any" and press Enter to include any IP address in the ACL.
Note that there is no default for this parameter.
Enter IP address or the word 'any' to denote any IP address:
Step 6
If you entered a specific IP address, enter the wildcard bits to define a range of IP addresses and press Enter.
(See
Entry Formats
To define an individual IP address, type 0.0.0.0 and press Enter.
There is no default for this parameter.
Enter wildcard bits:
The maximum number of entries in an ACL is 20.
Step 7
If the "any" option was used, no other IP addresses may be added to the list.
•
To add more entries, type y and press Enter
Would you like to add another entry to this list? [no]:y
Enter up to 20 entries as described in step 5 and step 6.
When all entries have been added, press Enter
•
Would you like to add another entry to this list? [no]:
When all entries are added to one list, you are asked whether you would like to create another ACL. You may
Step 8
define up to 99 ACLs.
•
To create another ACL, type y and press Enter
Would you like to configure another list? [no]: y
Enter up to 20 IP addresses in this new ACL, as described in step 5 and step 6.
When all ACLs have been created, press Enter.
•
Would you like to configure another list? [no]:
You are now prompted to assign the desired ACLs to restrict IP and Telnet access.
Step 9
Restrict IP access to the SCE 2000 by assigning the appropriate ACL.
Type the number of the ACL to be assigned to IP access and press Enter.
To accept the default ACL, press Enter.
Enter IP access-class [0]:
Restrict Telnet access to the SCE 2000 by assigning the appropriate ACL.
Step 10
Type the number of the ACL to be assigned to the Telnet interface and press Enter.
To accept the default ACL, press Enter.
(on page 25).)
27
Advertisement
Table of Contents
