Table of Contents
Advertisement
In certain cases, there will be two or more logically related parameters within a menu. In these situations, it is not
•
permitted to jump to the end of the setup dialog until all related parameters are configured. If you try to jump to the
end of the setup dialog, the following message will appear: "
."
stage
•
Certain groups of related parameters, such as time, date, and SNTP settings, form sub-dialogs or menus within the
setup dialog. You may skip an entire menu, thereby accepting all default values for the parameters within the menu.
Each group of related parameters is prefaced by a question, asking whether you want to enter the menu. To skip the
menu, answer no ("n") to the question.
E
:
XAMPLE
Would you like to enter the SNMP configuration menu? n
To abort the setup dialog at any point without making any configuration changes, press ^c. All changes already
•
entered will be lost, with the exception of time settings.
Step 1: Configuring Initial Settings
Verify the following initial settings for the SCE 2000:
IP address
•
Subnet mask
•
Default gateway
•
All values are Internet addresses of the form 'X.X.X.X', where each letter corresponds to a decimal number between 0 and
255.
To configure the initial settings, complete the following steps:
Step 1
The current IP address is displayed.
To accept the displayed value, press Enter.
•
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
•
The current subnet mask is displayed.
Step 2
•
To accept the displayed value, press Enter.
•
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
Step 3
The current IP address of the default gateway is displayed.
To accept the displayed value, press Enter.
•
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
•
Sorry, Skipping is not allowed at this
19
Advertisement
Table of Contents
