Step 2: Configuring The Hostname; Step 3: Setting The Passwords - Cisco SCE 2000 4/8xFE Quick Start Manual

E :
XAMPLE
The following example displays a typical configuration of the IP address (10.1.5.109), subnet mask (255.255.0.0), and
default gateway (10.1.1.3).
Since the IP address and the subnet mask are related, when the IP address is changed, there is no longer a default value of
the subnet mask, and it must be entered explicitly.
Enter IP address [10.1.1.201]:10.1.5.109
Enter IP subnet mask:255.255.0.0
Enter IP address of default gateway [10.1.1.3]:

Step 2: Configuring the Hostname

The hostname is used to identify the SCE 2000. It appears as part of the CLI prompt and is also returned as the value of
the MIB-II object sysName.
The maximum length is 20 characters.
The default hostname is SCE 2000.
To configure the hostname, complete the following steps:
The current hostname is displayed.
To accept the displayed value, press Enter.
•
To change the value, type any desired character string and press Enter.
•
Enter hostname [SCE 2000]:

Step 3: Setting the Passwords

Configure the passwords as follows:
Set the password for each authorization level (User, Admin, Root).
•
Enable/disable password encryption. When password encryption is enabled, it encrypts the previously entered
•
passwords.
Passwords are needed for all authorization levels in order to prevent unauthorized users from accessing the SCE 2000.
Note
Admin level should be used by the network administrator. Root level is for use by Cisco technician.
Passwords must meet the following criteria:
Minimum length — 4 characters
•
Maximum length — 100 characters
•
• Begin with an alpha character
• May contain only printable characters
20