Connecting The Management Interfaces And Performing Initial System Configuration; Connecting The Local Console - Cisco SCE 2000 4xGBE Installation And Configuration Manual

Connecting the Management Interfaces and
Performing Initial System Configuration
This chapter explains how to connect the SCE 2000 platform to a local console and perform the
initial system configuration via the setup wizard that runs automatically.
Additionally, this chapter contains instructions for cabling the Fast Ethernet Management
interfaces.
Note When installing a cascaded system, it is extremely important to follow the sequence of procedures
outlined in the section
This chapter contains the following sections:
•

Connecting the Local Console

•
Initial System Configuration
•
Connecting the Management Interface
Connecting the Local Console
Even if you will be managing the SCE 2000 from a remote location, you must first connect the
unit to a local console and configure the initial settings for the SCE 2000 to support remote
management. When the initial connection is established, the setup utility will run automatically,
prompting you to perform the initial system configuration.
OL-7824-04
Installing a Cascaded System
5-1
5-3
Cisco SCE 2000 4xGBE Installation and Configuration Guide
(on page 6-10).
5-25
C H A P T E R 5
5-1