Table of Contents
Advertisement
2G Lift Dialer
3.
CONFIGURATION
2G Lift Dialer can be configured with:
• Lift Manager Application for Android smartphones;
• SMS with mobile phone;
• phone or mobile phone calling the Emergency phone;
• common DTMF phone connected to pin 3-4 of the Emergency phone.
To access the configuration you must know the password.
In the factory configuration the password is 21010.
During the configuration by phone (local and remote) some sound signals are played to advise the installator of the
following situations:
CORRECT PASSWORD
CORRECT CONFIGURATION
WRONG CONFIGURATION
Together with the audio signals, you can verify the correct configuration from the red LED CONFIG of the 2G Lift Dialer:
CORRECT CONFIGURATION
WRONG CONFIGURATION
3.1.
CONFIGUratION VIa lOCal phONe
1. Connect a phone with a proper cable to pin 3-4 of the terminal board.
2. Off-hook the phone and wait for sound signal
operations.
3. Insert the password, default 21010, even during the message playing and wait for sound signal
In case of wrong password, the welcome message is repeated again and you will have to insert the password newly.
After 2 repetitions, the Emergency phone enables the speakerphone communication with Car1.
4. Insert the configuration according to CONFIGURATION TABLE.
5. After each command wait for sound signal
In case of sound signal
6. To complete the configuration, digit **# or hang up. If the configuration is not complete or you don't hang up, after a
few minutes Emergency phone automatically disconnect the communication and it restores the condition of standard
operation.
3.2.
CONFIGUratION VIa remOte phONe
1. Call the SIM phone number of 2G Lift Dialer.
2. Wait the answer from 2G Lift Dialer and the sound signal
possible operations.
3. Insert the password, default 21010, even during the message playing and wait for sound signal
In case of wrong password, the welcome message is repeated again and you will have to insert the password newly.
After 2 repetitions, the Emergency phone enables the speakerphone communication with Car1.
4. Insert the configuration according to CONFIGURATION TABLE.
DIALER READY
DIALER
CORRECT CONFIGURATION
WRONG
CONFIGURATION, repeat the command.
READY. A welcome message is played with the possible
before giving a new command.
DIALER
READY. A welcome message is played with the
Configuration
CORRECT
PASSWORD.
CORRECT
PASSWORD.
3.1
Advertisement
Table of Contents
