Table of Contents
Advertisement
2G Lift Dialer
2.4.
Before PoWering lift dialer on
Place 2G Lift Dialer where you prefer, in a zone with a good GSM signal, and go on as follows:
1. Open the SIM holder by slightly pressing and pushing it horizontally
toward the internal side of the card.
Now insert the SIM card. Pay attention to the SIM cut corner and be
sure the golden contacts of the SIM are turned downwards when closing
the SIM holder.
Close the SIM holder by slightly pressing and pushing it horizontally in
the opposite side to block it and correctly fix the SIM.
2. Connect the GSM antenna you find in the package to the golden SMA
connector. Screw it clockwise; in case of problem do not force but remove
the antenna and try again.
Apply the magnetic base of the antenna only on metal zone,
without connection to earth.
Please use eventually the metal support, find in the
package, fixed it to the wall.
3. Connect pins 5-6 of 2G Lift Dialer to pins 1-2 of Voice Box.
PINS CAN BE CROSSED.
For a good audio quality use a twisted pair for the connection. Otherwise you can use two unused wires already present
in the car cable or use the the wires already present and used for the bell after having modified the system as described
in paragraph RELAY1: BELL MANAGEMENT.
In this case the audio quality could not be the best one.
4. Connect eventually the external button (or buttons) on Voice Box.
5. Now power 2G Lift Dialer on following the polarity:
pin 21 : 12-24 Vdc
pin 22 : GND
We suggest to use Digicom power supply for 2G Lift Dialer:
Switching power supply (IN: 100-240 Vac / 50-60Hz / 0,5A – OUT 12 Vdc / 1A) (code 8D6065)
DIGICOM DOES NOT GUARANTEE A CORRECT OPERATION WITH OTHER POWER SUPPLIES.
6. Check the LED power on:
Power:
green fixed ON
GSM:
at the beginning OFF; after the affiliation to the GSM network it is yellow fixed ON or blinking.
1
5
10
ANTENNA
SIM
BATTERIA
15
20
22
MORSETTIERA
Installation
2.9
Advertisement
Table of Contents
