Changing The Language (Command 45*Xx#); Adjusting Speaker Volume And Microphone Gain; Activation Of Speakerphone In Car In Incoming Calls - Digicom 2G Lift Dialer User Manual

2G Lift Dialer

3.13. ChaNGING the laNGUaGe (COmmaND 45*XX#)

To select language of standard messages: comfort, alarm, welcome.
• 45*39#
Italian (default)
• 45*34#
Spanish
• 45*44# English
• 45*31#
Dutch
• 45*49#
German
Example: to select the English language via SMS: 2101045*44#
NOTE: The available languages depends of software version.

3.14. aDjUStING Speaker VOlUme aND mICrOphONe GaIN

It is possible to adjust the volume of the speaker and the gain of the microphone for the best performances in the various
installations.
• 421x# Microphone gain (values from 0 to 7). The factory value is 5.
• 422x# Speaker volume (values from 0 to 7). The factory value is 5.
Example:
to lower the microphone gain and make the speakerphone louder via SMS: 210104214#4227#
Attention: the factory values should satisfy the various situations.
In case of change for real needs, we suggest to carefully control the audio quality and the absence
of whistles. Check also the correct placement of microphone and speaker.

3.15. aCtIVatION OF SpeakerphONe IN Car IN INCOmING CallS

To get in contact with the people in the Car it is necessary:
• Call the SIM number of 2G Lift Dialer.
• After the anwer, wait for the tone and listen the instruction of the welcome message.
• Then digit * and the car number:
* 1 for car 1 - * 2 for car 2 - * 3 for car 3
The command can be sent at any time.
If no keys is pressed, after 2 playbacks of the welcome message 2G Lift Dialer tries to open the speakerphone
with car 1.
• Wait for the tone before starting the conversation.
• To exit the speakerphone and listen again to the welcome message, digit 10# ; wait for the tone and eventually insert
the code to enable the speakephone with another car or insert the password to access the configuration.
• It is possible to hang up at any time.
• The conversation will go on maximum 3 minutes. Time can be set with command 392[t]# .
A few seconds before the timer expires, you hear 2 beeps.
To extend the time at disposal for other [t] minutes, press the same code used to enable the speakerphone. The default
code is 3.
Configuration
3.9