Table of Contents
Advertisement
2G Lift Dialer
3.16. aCtIVatING the INterCOm FUNCtION (COmmaND *1 Or *2 Or *3)
The intercom function between the lift Car and the Control Center or the concierge service can be activated with a common
phone connected to pin 3-4 of the Emergency phone.
To activate the conversation with the people in the Car:
• Off-hook the phone and wait for the tone. Listen to the instructions of the welcome message.
• Then digit * and the car number:
* 1 for car 1 - * 2 for car 2 - * 3 for car 3
The command can be sent at any time.
If no keys is pressed, after 2 playbacks of the welcome message 2G Lift Dialer tries to open the speakerphone
with car 1.
• Wait for the tone before starting the conversation.
• To exit the speakerphone and listen again to the welcome message, digit 10# ; wait for the tone and eventually insert
the code to enable the speakephone with another car or insert the password to access the configuration.
• It is possible to hang up at any time.
• The conversation will go on maximum 3 minutes. Time can be set with command 392[t]# .
A few seconds before the timer expires, you hear 2 beeps.
To extend the time at disposal for other [t] minutes, press the same come used to enable the speakerphone. The default
code is 3.
3.17. relay 1 aND 2: maNaGemeNt FOr Gate OpeNING (COmmaNDS
81# aND 82#)
The Emergency phone is equipped with 2 relays
Relay1 N.O. (pin12-13) and Relays1 N.C. (pin13-14)
Relay2 N.O. (pin15-16) and Relay 2 N.C. (pin16-17).
Relay1 can be activated with command 81# .
Relay2 can be activated with command 82# .
Once the command is received, the Emergency phone changes the relay status for 3 seconds, restoring the initial status.
A typical use of the relay is to open the gate of the building where 2G Lift Dialer is installed.
If the Emergency phone is set for the bell management (command 84t#) the command Open gate 81# is ignored by
Emergency phone and then it is not managed.
3.10
Configuration
Advertisement
Table of Contents
