Power On And Startup For Fdap Gen3 - Honeywell OW-FDAP31 Manual

3 FDAP INSTALLATION
3.13

Power on and startup for FDAP Gen3

The FDAP Gen3 has status LED's to indicate the various stages of operation.
The following table identifies the LED's and describes the operating conditions of the unit when the LED's are
turned ON.
LED
Power LED (Red)
Ethernet Active LED (Green)
Ethernet Link LED (Green)
Status LED/Heart Beat LED (Green)
36 www.honeywell.com
Figure 9.1: LED indicators
Table 3.1: LED indicators
Description
Indicates that the power is supplied to FDAP Gen3. When the FDAP Gen3 is
powered ON, Power LED turns ON automatically.
Indicates that FDAP Gen3 is connected to FDN network . When the FDAP
Gen3 is connected to FDN Network, Ethernet Active LED turns ON
automatically.
Indicates the Ethernet link activity.
•
The LED is steady when there is a valid Ethernet link but no data activity.
•
The LED blinks when there is data activity on the Ethernet link.
Indicates the software status of FDAP Gen3 factory image. The Status LED blinks
ON/OFF once every second to indicate that the FDAP Gen3 factory firmware is in
the working condition.