Fdap Compliance Information - Honeywell OW-FDAP31 Manual

3 FDAP INSTALLATION
2.7

FDAP compliance information

RED (Radio Equipment Directive)
This device complies with EN 302372 of the R&TTE Directive The device does not cause harmful interference
and accepts any interference received.
WARNING! Changes or modifications made to this equipment not approved by Honeywell invalidate the
compliance to RED.
FCC (Federal Communication Commission) Compliance Statement
FCC information: (FCC ID: S5751307990)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
◼ Reorient or relocate the receiving antenna.
◼ Increase the separation between the equipment and receiver.
◼ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
◼ Consult the dealer or an experienced radio/TV technician for help.
CAUTION! Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
WARNING! In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 7.9inches (20cm) or more from the body of all persons.
WARNING! Since the product uses standard antenna connector, thus only professional installation is permit-
ted.
16 www.honeywell.com