Honeywell OW-FDAP31 Manual page 60

4 FDAP CONFIGURATION
4. In the Modbus Interface list, click the required option. The following
are the interface options available.
•
•
Attention
Based on the connected Modbus devices, select the appropriate option.
5. Configure one of the following depending on the Modbus interface option that you have selected.
•
•
50 www.honeywell.com
Modbus RTU
Modbus TCP
If you have selected Modbus TCP Interface, configure the following under Modbus TCP Settings.
o
FEWIO IP Addr: IP address that needs to be assigned to FEWIO and the IP address Subnet
o
Subnet Mask: Subnet Mask
o
Gateway: Gateway IP address.
o
Slave1 IP Addr: IP address of Slave1
o
Slave2 IP Addr: IP address of Slave2
o
Slave3 IP Addr: IP address of Slave3
o
Slave1 UnitID: Unit ID of Slave1 used for the Modbus TCP port.
o
Slave2 UnitID: Unit ID of Slave2 used for the Modbus TCP port.
o
Slave3 UnitID: Unit ID of Slave3 used for the Modbus TCP port.
If you have selected Modbus RTU Interface, configure the following under Modbus RTU Settings.
o
Baud Rate: Select the baud rate used for the Modbus RTU serial port. Options include:
9600,19200, 38400, 57600, 11520.
o
Parity: The parity used for the Modbus RTU serial port. Options include: Even and Odd.
o
Stop Bits: Options include: 1 and 2.
should be same as the IP address of slaves.