Physical Description; Fdap Gen3 And Fdap Gen3 Anchor Components - Honeywell Field Device Access Point User Manual

Physical description

FDAP Gen3 and FDAP Gen3 Anchor components

FDAP Gen3 and FDAP Gen3 Anchor enclosure
Bluetooth Low Energy (BLE) Module
The FDAP Gen3 and FDAP Gen3 Anchor have a rugged die-cast aluminum enclosure for
outdoor use. The enclosure and all auxiliary components are designed to meet IP66 and
IP67 ratings for protection against dust and water ingress. The enclosure has two N-type
bulkhead connectors for antenna spatial diversity in the FDAP radios. The two of the half-
inch rigid conduit hub has a gasket to seal out water and dust. A rigid conduit hub, internal
and external ground studs, and a removable cover are provided for field installation. It has
an internal Bluetooth Low Energy (BLE) module, and this allows the device to be
commissioned in the field. Six status LEDs provide information about power, device health,
Bluetooth, RS-485 and Ethernet communication. The enclosure may be mounted on a
pole or on a flat surface such as a wall using the available optional mounting brackets. The
enclosure measures approximately 47 cm x 29 cm x 5 cm (L x W x H).
FDAP Gen3 and FDAP Gen3 Anchor
Fig. 2.
The FDAP Gen3 and FDAP Gen3 Anchor have an internal BLE module that is used for
communicating with the Provisioning Handheld Android device. The Provisioning
Handheld device is used for commissioning the FDAP Gen3 and FDAP Gen3 Anchor,
reading, and setting the various FDAP Gen3 and FDAP Gen3 Anchor parameters. The BLE
module has a range of 10-meter radius.
OWDOC-X256-en-323A 11