Changing Batteries; Low Power Mode; Unlinking The Scanner From Access Point - Honeywell AP-100BT Quick Start Manual

Changing Batteries

If the scanner turns off due to a low battery, you can change the
battery without losing the link with the Access Point, provided
the scanner is in range. A few seconds after the scanner pow-
ers up, the scanner relinks to the Access Point. Refer to your
User's Guide at www.honeywellaidc.com for additional informa-
tion about charging the batteries.

Low Power Mode

When there is no activity within a specified time period, the
scanner enters a low power mode. The default time out period
is one hour. Pull the scanner's trigger to power the scanner
back up. If the scanner was linked to the Access Point when it
went to "sleep," it will re-link as long as it is in range.
If multiple scanners use the same Access Point, it is possible to
inadvertently unlink a scanner that is in "sleep" mode, that has a
dead battery, or is in the process of getting a new battery. To
prevent this from happening, you can disable the sleep mode
(time out) by scanning the No Time Out bar code below.
No Time Out (0)

Unlinking the Scanner from Access Point

If you know that your scanner is not going to be used for a while,
you can unlink the scanner by scanning the Unlink Scanner
bar code below.
Unlink Scanner