Manually Pairing An Srx3 Headset With An A500, A700, Or A700X Talkman Device; Screen-Based Pairing With A Handheld Device - Honeywell SRX3 User Manual

6. Press the Play/Pause button on the Talkman device to confirm the number.
7. Press the Play/Pause button again to begin working.
Manually Pairing an SRX3 Headset with an
A500, A700, or A700x Talkman Device
Prerequisites:
l
l
l
l
1. Turn on the headset.
2. Press and hold the Plus (+) and Minus (-) buttons on the Talkman device for
3. Immediately hold the headset and device so they are within six inches of
4. Put on the headset. You will hear the headset repeat the serial number of the
5. Verify that the number matches the serial number on the Talkman device.
6. Press the Play/Pause button on the Talkman device to confirm the number.
7. Press the Play/Pause button again to begin working.

Screen-Based Pairing with a Handheld Device

Screen-based pairing is the preferred method for pairing an SRX3 headset with
a handheld wireless device or PC. This method allows the user to pick a specific
headset from a list of available headset Bluetooth addresses displayed on a
screen, and eliminates the problem of unwanted cross pairing. Auto and manual
pairing processes are not available in screen-based pairing.
Prerequisites:
37
The headset is powered off.
The Talkman device is not in a charger, and there is no wired headset
connected to it.
The Talkman device is in sleep mode — not in use running a task or voice
application. Its green LED indicator is flashing. If the LED is solid green,
press the Play/Pause button.
The Talkman device is Bluetooth ready with Bluetooth connection features
enabled.
The LED indicator is solid green. The headset remains in pairing mode for
ten minutes then powers off.
two seconds to manually initiate a search for wireless headsets.
each other but not touching.
The blue LED indicator on the Talkman device turns on, may flash a few
times, and then remains lit. After 20 to 30 seconds, the headset beeps three
ascending tones and its LED indicator flashes blue. These indicators confirm
that a pairing has completed.
Talkman device to which it is paired.
If you need to attempt the pairing again, re-enter pairing mode by press the
Plus (+) and Minus (-) buttons on the Talkman device again.
SRX3 User Guide - Preliminary