Auto Pairing An Srx3 Headset With An A500, A700, Or A700X Talkman Device - Honeywell SRX3 User Manual

Auto Pairing an SRX3 Headset with an A500,
A700, or A700x Talkman Device
Prerequisites:
l
l
l
1. Reboot the Talkman device or remove it from a charger to initiate a scan for
2. Turn on the headset.
3. Hold the headset and Talkman device so they are within six inches of each
4. Put on the headset. You will hear the headset repeat the serial number of the
5. Verify that the number matches the serial number on the Talkman device.
SRX3 User Guide - Preliminary
Using TouchConnect to Obtain Operator
Information from the Headband
When the device starts the task, VoiceConsole recognizes the pairing.
The headset is powered off.
There is no wired headset connected to the Talkman device.
The Talkman device is Bluetooth ready with Bluetooth connection features
enabled.
IMPORTANT
An unpaired device will constantly search for wireless headsets while in
auto pairing mode. Do not leave an auto pair-enabled device unpaired and
powered on because the search will drain the battery.
headsets.
The headset will remain in pairing mode for ten minutes. If not paired
within ten minutes, it powers off.
other but not touching.
The blue LED indicator on the Talkman device turns on, may flash a few
times, and then remains lit. After 20 to 30 seconds, the headset beeps three
ascending tones and its LED indicator flashes blue. These indicators confirm
that a pairing has completed.
Talkman device to which it is paired.
If you need to attempt the pairing again, re-enter pairing mode by pressing
and releasing the Plus (+) and Minus (-) buttons on the headset control
panel.
Using TouchConnect to Pair an
SRX3 with an A700 Device
36