Removing A Battery From An Srx3 Wireless Headset; Srx3 Battery Warm-Up Time - Honeywell SRX3 User Manual

Removing a Battery from an SRX3 Wireless
Headset
1. Power off the headset by pressing and holding the Power button on the
2. Grasp the headset by the sides of the electronics module with your thumb
3. With your other hand, hold the battery at the end of the electronics module
4. Press and hold both battery latches at the same time, squeezing them into

SRX3 Battery Warm-Up Time

If a battery has been used in an extreme hot or extreme cold environment,
charging will not start immediately.
When the battery is placed in the charger, the battery port LED indicator will
turn yellow. Charging will only begin after the battery reaches the proper
temperature range - 32° F (0° C) to 104° F (40° C). It may take up to 30
minutes for the battery to reach a safe temperature.
If battery temperature does not come into range in about one hour, the red LED
will blink indicating that there is a charger fault.
SRX3 User Guide - Preliminary
WARNING
Replace a battery only with another battery that has been authorized by
Honeywell for the product you are using. Use of an unqualified battery may
present a risk of fire, explosion, leakage, or other hazard. See also
Honeywell Battery Safety
IMPORTANT
Do not remove the battery from the SRX3 headset until the LED indicator
on the headset is off.
electronics module for one second.
and fingers on the black battery latches.
opposite the mic boom.
the sides of the electronics module until the battery releases from the
electronics module.
16