Wearing The Srx3 Hard-Hat Headset - Honeywell SRX3 User Manual

Wearing the SRX3 Hard-Hat Headset

The SRX3 Hard-Hat Headset fork and disk assembly has two lock positions that allow for
easy wearing, removing and storing the hard hat with the headset attached. The inner
position keeps the earcup snug to the ear; the outer position enables the headset to be
swiveled in the clip without causing wear to headset parts or to the hard hat.
1. Hold the hard hat firmly.
2. Push the headset earcup in toward the head area of the hat until it snaps
3. Slide the hard hat onto your head, pulling the earcup out as needed, then
4. If the earpad sits too low or high on your ear, take off the hard hat and
5. Insert the SRX3 electronics module into the pocket on the earcup by
6. Push the electronics module into the earcup pocket until it is firmly seated.
SRX3 User Guide - Preliminary
into its inner position.
position the hat so the earpad is snug against your ear.
adjust the earcup by pulling or pushing the arms of the fork out of or into
the fork sleeves.
aligning the notches on the speaker and earcup pocket.
26