Installing The Srx3 Hard-Hat Clip - Honeywell SRX3 User Manual

Installing the SRX3 Hard-Hat Clip

The SRX3 Hard-Hat headset attaches to the side of a hard hat using a clip that
must be mounted on the hard hat. Honeywell offers two clip styles, one
designed to insert in a hard-hat slot and one that mounts over the side brim of
a non-slotted hard hat. Other hard-hat clips may be purchased and used
provided that they fit the hard hat and attach correctly to the SRX3
earcup. Vendors such as Howard Leight™ offer these products.
l
l
SRX3 User Guide - Preliminary
NOTE
The hard-hat clips are not designed for frequent removal. It may be
necessary to order extra clips if users intend to alternate wearing the
headset earcup on the left and right sides.
Inserting a slotted-mount clip in a hard hat
Position the clip with the tab pointing into the slot on the side of the
o
hard hat.
The angle of the clip should follow the contour of the hard hat with the
o
rubber stops on the back side of the clip facing the hard hat.
Align the tab of the clip to fit into the slot.
o
Slide the clip into the slot until the tab clicks in place and it is firmly
o
seated.
Mounting a brim-mount clip on a hard hat
Loosen the screws that secure the two clip brackets to the clip.
o
For large brim hats, it may be necessary to remove the brackets
completely in order to fit them over the brim without the clip in place.
From the under side of the hat, slide the brackets over the brim. If the
o
brackets were removed, slide the bracket ends back under the screws in
the clip.
24