Cross Pairing; Srx3 Headset Pairing Methods - Honeywell SRX3 User Manual

This parameter defaults to 1, which causes pairings to be persisted and re-
established when the device is powered on.
When SrxAutoPairEnable is enabled (set to 1),
PersistSrxPairingAcrossPowerCycle defaults to 0.
SrxClearPairingInCharger
Set to 1 to clear the pairing when the device is placed into a charger.
This parameter defaults to 0, or maintaining the pairing.
When SrxAutoPairEnable is enabled (set to 1), SrxClearPairingInCharger
defaults to 1.
SrxAutoPairEnable
Set to 1 to turn on automatic pairing.

Cross Pairing

Cross pairing is the result of a master device pairing with a headset or other
device that is not the intended slave. If a user cannot isolate his or her device
and headset from others and a cross pairing occurs, the user should break the
existing pairing and retry the intended pairing.

SRX3 Headset Pairing Methods

After an SRX3 headset enters low or high power pairing mode, it is available to
accept a pairing initiated by a Talkman A700-series, Talkman A500, Talkman T5-
Series, or other Bluetooth-enabled device. These pairings can be accomplished
using a variety of methods:
The SRX3 headset must be in high power pairing mode to pair with a handheld
device. To place the SRX3 headset in high power pairing mode, press and hold
the Plus (+) and Minus (-) buttons for seven seconds. By setting the
SrxHighPowerPairingDelaySeconds configuration parameter, you can
configure how long an operator must hold the Plus and Minus buttons before
entering high-power pairing mode or set the parameter to have the headset go
directly into high-power pairing mode. After an SRX3 headset enters high power
pairing mode, it is available to accept a pairing initiated by a Bluetooth-enabled
handheld device. These pairings can be accomplished using a variety of
methods:
SRX3 User Guide - Preliminary
TIP
Prevent unwanted cross pairing by isolating the device and headset from
all other Bluetooth devices any time that the device is performing an
inquiry scan to find the headset or pair manually. Cross pairing is extremely
unlikely when a user uses touch pairing.
32