About Led Indicators; Headset Battery Charger Led Indicators - Honeywell SRX3 User Manual

3. Slide the charger horizontally to the desired position on the rail, and rotate
4. If the charger does not feel secure on the rail, adjust the rubber stops on the
5. Plug the power supply into a power source and check the LED indicator at

About LED Indicators

Vocollect Talkman devices, headsets, and their chargers have LEDs that indicate
the state of the equipment. These LEDs may be on, off or blink. In some cases
an LED will blink, alternating between two colors.
If the LEDs indicate that there is a problem, refer to information on
troubleshooting to solve the problem. See also Troubleshooting Problems
Indicated by LED.

Headset Battery Charger LED Indicators

The headset battery charger has an LED indicator light, located at the bottom
right of the charger face, that signals the status of the charger.
l
l
l
Charger Port Indicators
SRX3 User Guide - Preliminary
the locking arms into the locked position - flush with both sides of the unit.
back of the unit by screwing them out toward the wall.
the bottom right of the charger face. If the indicator light is a solid green,
the charger is powered on.
Solid green LED: Charger power is on
No light: Charger power is off
Solid red LED: Charger is experiencing a power fault (SRX2 only)
NOTE
If the charger LED indicator is red, unplug the charger power supply
from the power source, and remove all batteries. Plug the power supply
into the power source again. If the LED remains red, the charger may
require repair or replacement.
48