Honeywell SRX3 User Manual page 53

Minimum
Number of
cut
chargers
lengths for
on rail
rail
1 550 mm
2 1101 mm
3 1652 mm
l
l
l
1. Install the DIN rail on the wall in the desired location. Ensure that the secure
2. Attach the charger to the DIN rail by hanging the two hooks on the back of
47
DIN rail specs
Single unit length 550 mm; weight
331.5 g (11.6933 oz)
Drill
Fasteners
Screw driver
installation, supporting surface, and mounting hardware will safely support
the weight of a fully loaded charger, at 25 lbs. per linear foot (37.2 kg/m) of
DIN rail. Ensure that the anchor holes are at least 12 inches (30.5 cm.) from
the floor. Verify that the installation meets all local building codes.
IMPORTANT
The power supply for the charger should already be zip-tied in the back
of the charger chassis. If it is not, plug the power supply into the
charger and secure it. Do not plug it into a power source until after
mounting is complete.Before attaching the charger to the rail, open the
locking arms on the back of the unit by rotating the two levers out on
each side of the charger. The arms are parallel to the floor in the
unlocked position.
the unit on the top lip of the rail.
Standard DIN rail
SRX3 User Guide - Preliminary