Setting Up A Site Configuration For A Redundant Ciu 888 System Setup - Honeywell CIU 888 Migration Manual

FIGURE 3-6
NOTE: Refer to the Protocol Manual - CIU Emulation (Part No. 4417589) for more
NOTE: Refer to the Instruction manual Ensite Pro Configuration Tool version 3.0 (Part
3 - 8
Commissioning of a Redundant System Setup
configuration of primary CIU Prime host port 2, with the exception of the RTU
address which must be unique.
Ensite Pro: Edit CIU Prime window - CIU emulation enabled
information about CIU Emulation.

3.3.3 Setting up a site configuration for a redundant CIU 888 system setup

Since the procedure for setting up the site configuration for a redundant
system setup is similar to the procedure for setting up the site
configuration for a standalone system setup, this section focuses on the
changes that need to be made when setting up the site configuration of
a redundant system setup.
No. 4416593) for detailed information about setting up a site configuration
using Ensite Pro.
The site configuration for a redundant system setup contains two

CIU Primes: a primary CIU Prime and a secondary CIU Prime. The
configuration settings of both CIU Primes must be the same with the
exception of the RTU addresses of the configured host ports. These
must be unique.
Ensite Pro to CIU 888 Migration Manual
CIU 888
Part No.: 4417593_Rev09