Cisco TelePresence 3000 Installing And Removing page 51

Setting Up the Presentation Display
Set up the presentation display for first-time use by completing the steps in this section.
Step 1 Make sure that a serial cable is connected from your display to the Serial 1 output of the auxiliary control
unit. See the "Options for the Cisco TelePresence System 3010" chapter of the
Hardware Options and Upgrade Guide
Control Unit.
Start a test pattern display for the display by completing the following steps:
Step 2
a.
b.
c.
d.
e.
Turn on the display.
Step 3
If the display does not show a test pattern, see the
attempt to fix the problem.
From Cisco TelePresence System Administration, click Set LCD Defaults to automatically configure
Step 4
the display for use with the Cisco TelePresence system.
Although the 40-inch display ships with a remote control, Cisco strongly recommends that you not make
Note
any adjustments or changes from the factory default settings. The TelePresence system restores the
display to its factory default settings each night and any overrides to the default settings will not persist.
Troubleshooting the Display
Use
Table 1-3
Problem
Test pattern is not displayed.
Test pattern is not displayed.
OL-23393-01
Open a browser that is connected to the network.
Enter the IP address of the primary codec to log in to Cisco TelePresence System Administration.
Select Troubleshooting > Hardware Setup, then click the Presentation Devices radio button.
Select the Test Pattern radio button.
Click Start to begin the test.
Table 1-3 to troubleshoot problems with the display.
Troubleshooting Chart for Presentation Device Problems
for information about cabling your system with an Auxiliary
"Troubleshooting the Display" section on page 51
Possible Cause
Display power switch is off.
Power cable is not connected.
Cisco TelePresence
Possible Solution
Check projector power switch.
Check the power cable.
to
51