Pull the speaker board out approximately six inches (15 cm).
Step 4
Loosen the screws that attach the spade terminals and speaker cable to the speakers, then remove the
Step 5
cables from the speaker.
Remove the speaker board.
Step 6
Repeat
Step 7
Remove all speaker board brackets and either the screen clips or locating plate for the screen.
Step 8
The top illustration in
and the locating plate; remove either the clip or the plate, depending on your system.
Make a note of the hole location for the clips or plates; you use these same holes to install the new plates
Note
in
Step 4
section on page
Figure 5
OL-23393-01
Step 3
through
Step 7
to remove the center and right speaker boards and speakers.
Figure 5
shows the speaker board brackets. The lower illustration shows the clip
of the
"Attaching the Screen and Shelf Attachment Hardware and Display Frame Brackets"
12.
Speaker Board Bracket
11