Cisco TelePresence 3000 Installing And Removing page 44

Attaching the Screen Assembly to the Cisco TelePresence
System
This section describes the procedure you perform to attach the screen assembly to the
Cisco TelePresence system and includes the following topics:
•
•
Required Parts and Tools
•
•
•
•
•
Attaching the Screens and Display to the Cisco TelePresence System
To attach the screen assembly to the Cisco TelePresence system, complete the following steps.
Make sure the PDUs are powered off.
Step 1
Open the table door and slide the right screen through the door.
Step 2
Position the screen so that it is on the right side.
Step 3
You correctly position the screen later in this procedure.
Note
Figure 1-35
44
Required Parts and Tools, page 44
Attaching the Screens and Display to the Cisco TelePresence System, page 44
1 left Frame
1 right Frame
1 LCD screen
1 HDMI cable
1 open ended wrench
Positioning Screen Into the Right Side of the System
OL-23393-01