Sony SRS-HG10 Help Manual page 54

Help Guide
Wireless Speaker
h.ear go 2 (SRS-HG10)
Connecting to a Wi-Fi network using the Wi-Fi Protected Setup (WPS) button of the
wireless router
If your wireless router has a Wi-Fi Protected Setup (WPS) button, you can connect to the Wi-Fi network by this method.
To check if your wireless router is compatible with Wi-Fi Protected Setup (WPS), refer to the operating instructions of
your router.
Do the following before starting.
Place the speaker closer to the wireless router.
Turn on the speaker.
1
Press and hold the UPDATE/WPS button on the rear of the speaker until a beep is heard (for about 2
2
seconds).
The NETWORK indicator lights up in white and the LINK indicator flashes in orange.
Press the Wi-Fi Protected Setup (WPS) button* of the wireless router.
3
Operate within 90 seconds after pressing the UPDATE/WPS button of the speaker. Depending on the wireless
router, press and hold the Wi-Fi Protected Setup (WPS) button of the wireless router for a few seconds. For details,
refer to the operating instructions of your wireless router.
*
The position and shape of the Wi-Fi Protected Setup (WPS) button differ depending on the wireless router.
Check that the LINK indicator changes from flashing to staying lit in orange.
4
When the Wi-Fi connection is established, the LINK indicator lights up in orange.
Depending on the environment, it may take more than a minute for the LINK indicator to light up.
54