Honda NSX-T 1998 Manual page 471

Main Menu
9. Install the CKP/CYP sensor on the front cylinder
head.
CKP/CYP SENSOR
6 x 1.0 mm
12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
10. Install the front and rear back covers.
RUBBER SEALS
REAR BACK COVER
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
RUBBER SEAL
Table of Contents
RUBBER SEALS
FRONT BACK COVER
11. Insert the dowel pins in the camshaft pulley.
12. Install the camshaft pulleys, then tighten the retain-
ing bolts to the torque specified.
CAMSHAFT PULLEYS
RETAINING BOLTS
10 x 1.25 mm
69 N-m (7.0 kgf-m, 51 Ibf-ft)
13. Install the timing belt (see page 6-18).
14. Adjust the valve clearance (see page 6-9).
15. Inspect the rocker arms (see pages 6-7, 6-8).
16. Install the head cover gasket in the groove of the
cylinder head cover. Seat the recesses for the
camshaft first, then work it into the groove around
the outside edges.
NOTE:
• Before installing the head cover gasket, thor-
oughly clean the seal and the groove.
• When installing, make sure the head cover gasket
is seated securely in the corners of the recesses
with no gap.
HEAD COVER
GASKET
Clean.
RUBBER
SEAL
CORNERS OF
THE RECESSES
CORNERS OF
THE RECESSES
CYLINDER HEAD
COVER
(cont'd)