Honda NSX-T 1998 Manual page 293

Main Menu
29. Install the new boot bands on the boot and bend both
sets of locking tabs.
30. Lightly tap on the doubled portions to reduce their
height.
NOTE: After assembling, slide the rack right and left
to be certain that the boots are not deformed or
twisted.
31. If the tie-rod ends were removed, install the tie-
rods on the right and left rack ends and screw them
in until the threaded section is 11 mm (0.4 in) in
length.
32. Install the gearbox on the front crossbeam (see
page 17-20).
33. Check the wheel alignment and adjust if necessary
(see section 18).
Table of Contents