Table of Contents
Advertisement
Main Menu
Left Side Cover
Removal
NOTE:
• Clean all parts thoroughly in solvent or carburetor cleaner, and dry with compressed air.
•
Blow out all passages.
• Cut the lock tabs of each shaft locknut using a chisel, then remove the locknuts and conical spring washers from each
shaft.
• Countershaft locknut has left-hand threads.
1.
Remove the vehicle speed sensor (VSS) cover, then reinstall three bolts around the driveshaft oil seal.
CAUTION:
Do not damage the driveshaft oil seal lip.
2. Slip the special tool onto the mainshaft, and engage the parking brake pawl with the parking gear.
3.
Remove the transmission left side cover in the following numbered sequence.
NOTE:
Remove the special tool from the mainshaft after removing the locknuts.
Table of Contents
CAUTION:
Protect the lip of the
driveshaft oil seal by reinstalling three
bolts, after removing the speed sensor
cover.
MAINSHAFT HOLDER
07924-PJ4010A
NOTE: Cut the lock tabs of each shaft locknut
using a chisel, then remove the locknuts and
conical spring washers.
CAUTION: Keep all of the chiseled particles
out of the transmission.
Advertisement
Chapters
Table of Contents
