Magnetic Lock - Honeywell IdentIPoint Installation Instructions Manual

HONEYWELL IDENTIPOINT™ INTELLIGENT SMARTCARD SYSTEM

Magnetic Lock

Magnetic lock connected directly to the reader:
LEGEND
DC – Power
12VDC/24VDC
Magnetic Lock
1. Connect 12VDC+ of the power supply to pin 4 (Relay-
NC) or pin 3 (Relay-C) of the reader and 12VDC- to the
-ve pin of the magnetic lock.
2. Connect either pin 4 (Relay-NC) or pin 3 (Relay-C),
whichever is left free, of the reader to the +ve pin of the
magnetic lock.
In this setup, the door will remain locked as long as power is
provided and will unlock in the absence of power. If the reader
is powered off in this situation, the door will unlock.
95-7767
Power – Min. 18 AWG
Power Gnd – Min. 18 AWG
+
_
_
BLK
RED
+
1457020-001
Diode Suppression Diode Suppression
Network
Fig. 27. Connections between reader and magnetic lock
Ethernet
J9 PIN PIN
9
SAI-1-GND
8
SAI-1
SAI-0-GND 7
6
SAI-0
5
R l e y a N - O
4
Relay-NC
3
Relay-C
2
Power-GND
1 1
Po er IN Power-IN
IdentIPoint Reader
NOTE: The above describes one way of wiring the mag-
netic lock. Wiring must be done strictly as per the
stipulated safety codes that the building must
follow. Accordingly, the wiring would be either
done in a fail-safe or fail-secure configuration.
For description of reader pins refer to Table.5 and Table.6.
34
J10
1
Power-OUT
2
Power-GND
3 RS485-A
4 RS485-B
5 RS485-GND
6 DO
7 DOGnd
SAI-2
8
SAI-2-GND SAI 2 GND
9 9
Frame-GND
10
OFF ON
1
2
3 3
4
S1