Honeywell IdentIPoint Installation Instructions Manual page 3

WARNING
Fire Safety and Liability Notice: Never connect
card readers to any critical entry, exit door, barrier,
elevator or gate without providing an alternative
exit in accordance with all fire and life safety
codes pertinent to the installation. These fire and
safety codes vary from city to city and you must
get approval from local fire officials whenever
using an electronic product to control a door or
other barrier. Use of egress buttons, for example,
may be illegal in some cities.In most applications,
single action exit without prior knowledge of what
to do is a life safety requirement. Always make
certain that any required approvals are obtained in
writing. Verbal approvals are not valid.
IMPORTANT
1 For UL294 applications, only UL294 and/or UL1076 listed power supplies should be used for reader and
lock power with required 72 hour battery backup.
2 Use of PoE is not a UL294 listed configuration and should not be used on UL294 applications.
3 Wifi network configuration is not a UL294 listed configuration and should not be used on UL294
applications.
4 As a standalone or disconnected reader is not supervised, this configuration should not be used on
UL294 applications.
5 For UL294 applications using an IOM, note that the IOM needs to be kept on the secure side of the door
i.e. indoors, and within a distance of 7.5 meters from the reader to which it is connected. In case the
distance between the IOM and the reader exceeds 7.5 meters, the use of lightning protection devices on
the RS485 line is mandatory.
6 The class of these products is a UL294 Access Control System, complying with UL294 Attack
Class I.
IDENTIPOINT HARDWARE
Inside the reader box
• Intelligent Reader Unit - 1
• Mounting Plate - 1
• Mounting Hardware - Screws and Wall Anchors - 6 each
• Extra Tamper Resistant Screws - 2
• Tool for Tamper Resistant Screw - 1
• Connector with cable - 2 (9 and 10 pin)
• Resistors - 2K (Color Code: RED-BLACK-RED-GOLD;
0.5W axial type, 5% tolerance) - 3
• Resistors - 1K (Color Code: BROWN-BLACK-RED-GOLD;
0.5W axial type, 5% tolerance) - 3
• Square ferrite clip - 1
• Round ferrite clip - 1
• Quick Installation Guide - 1
Inside the IOM box
• Input / Output Module Unit - 1
• Mounting Hardware - Screws and Wall Anchors - 3 each
HONEYWELL IDENTIPOINT™ INTELLIGENT SMARTCARD SYSTEM
Table 1.
• Extra Tamper Resistant Screws - 2
• Tool for Tamper Resistant Screw - 1
• Connectors for termination - 12 x 2 connections; 3 x 3
connections
• Resistors - 2K (Color Code: RED-BLACK-RED-GOLD;
0.5W axial type, 5% tolerance) - 4
• Resistors - 1K (Color Code: BROWN-BLACK-RED-GOLD;
0.5W axial type, 5% tolerance) - 6
• Quick Installation Guide - 1
ASSEMBLY, MOUNTING AND
INSTALLATION
Mounting and Installing the Reader
NOTE:
• The reader can be mounted either on a drywall or on
a concrete wall using conduits and a gang box.
3 95-7767