Honeywell IdentIPoint Installation Instructions Manual page 33

1. Connect 12VDC+ of the power supply to pin 5 (Relay-
NO) or pin 3 (Relay-C) of the reader and 12VDC- to the
-ve pin of the strike latch.
2. Connect either pin 5 (Relay-NO) pin 3 (Relay-C), which-
ever is left free, of the reader to the +ve pin of the strike
latch.
In this setup, the door will remain locked in the absence of
power and will be unlocked when power is provided. If the
reader is powered off in this situation, the door will remain
locked.
1. Connect 12VDC+ of the power supply to either the NO
or Common pin of Relay 0 or 1 (J12 or J13) of the IOM,
and the 12VDC- to the -ve pin of the strike latch.
2. In the same port (J12 or J13), connect the NO or Com-
mon, whichever is left free, to the +ve pin of the strike
latch.
In this setup, the door will remain locked in the absence of
power and will be unlocked when power is provided. If the
reader is powered off in this situation, the door will remain
locked.
DI-0 GND
GND DO-0
DI-1 GND
GND DO-1
SAI-0 GND
GND ILK-0
SAI-1 GND
GND ILK-1
SAI-2 485-
GND
GND 485-B
SAI-3 485-A
GND N.C
SAO N.O
GND RLO-C
12V N.C
GND N.O
RL1-C
FGND
IO module
Fig. 26. Connections between IOM and strike latch
HONEYWELL IDENTIPOINT™ INTELLIGENT SMARTCARD SYSTEM
NOTE: The above describes one way of wiring the strike
latch. Wiring must be done strictly as per the
stipulated safety codes that the building must
follow. Accordingly, the wiring would be either
done in a fail-safe or fail-secure configuration.
For description of reader pins refer to Table.5 and Table.6.
Strike latch connected to the IOM:
LEGEND
Power – Min. 18 AWG
Power Gnd – Min. 18 AWG
+ +
DC – Power
12VDC/24VDC
_ _
BLK
RED
NOTE: The above describes one way of wiring the strike
latch. Wiring must be done strictly as per the
stipulated safety codes that the building must
follow. Accordingly, the wiring would be either
done in a fail-safe or fail-secure configuration.
For description of IOM pins refer to Table.8.
33
Strike Latch
_ _
1457020 -001
Diode Suppression
Network
+ +
95-7767