Honeywell IdentIPoint Installation Instructions Manual page 7

GANG BOX EMBEDDED IN WALL
USE THE SCREWS PROVIDED
TO FIX THE READER BACK-
PLATE TO THE EMBEDDED PLATE TO THE EMBEDDED
GANG BOX.
NOTE: USE A MINIMUM OF 2
SCREWS IN THE HOLES
CIRCLED IN RED TO FASTEN
THE BACK-PLATE
Fig. 5. Mounting reader back-plate on concrete wall using gang box and conduit
Fig. 6. Routing the wires before plugging the connectors into the reader
HONEYWELL IDENTIPOINT™ INTELLIGENT SMARTCARD SYSTEM
CLIP ROUND FERRITE CLIP ON
THE FIELD ETHERNET CABLE THE FIELD ETHERNET CABLE
WITH TWO TURNS WRAPPED
ROUTE THE RJ45 CONNECTOR
(IF REQUIRED) AND MOLEX (IF REQUIRED) AND MOLEX
TERMINALS FROM BEHIND THE
DRYWALL OR THROUGH THE
CONDUITS (IN CASE OF
CONCRETE WALL) AND BRING
THEM TOWARDS THE FRONT
SIDE OF THE MOUNTING
SURFACE THROUGH THE
OPENING ON THE READER'S OPENING ON THE READER'S
BACK-PLATE.
PLUG THE RJ45 CONNECTOR
INTO THE ETHERNET PORT OF
THE READER AT THE END OF
THE PIGTAIL.
PLUG THE MOLEX TERMINALS PLUG THE MOLEX TERMINALS
INTO THE J9 AND J10 PORTS
OF THE READER
7 95-7767