Honeywell IdentIPoint Installation Instructions Manual page 8

HONEYWELL IDENTIPOINT™ INTELLIGENT SMARTCARD SYSTEM
NOTE: Round ferrite clip is required for the unit to limit emissions within FCC part 15 Class B level. Can be clipped
either near the reader or at the far end (near the network switch) of the field Ethernet cable.
The connector wire colors shown above are only indicative. Refer to Table.5 and Table.6 for the correct colors.
PIN 9
PORT
J9
PIN 1
TO PIN 1
TO PIN 9
9-PIN MOLEX
TERMINAL
NOTE: Square ferrite clip is required for the unit to limit emissions within FCC part 15 Class B level. Should be clipped
on the reader's Ethernet pigtail and accommodated behind the drywall or inside the gang box. The connector
wire colors shown above are only indicative. Refer to Table.5 and Table.6 for the correct colors.
95-7767
HOLD THE 9 AND 10-PIN
MOLEX TERMINALS
PERPENDICULAR TO THE
BACK OF THE READER AND BACK OF THE READER AND
ALIGN THEM CORRECTLY
WITH PORTS J9 AND J10
Power
Activity
Model: BTSTD
IdentIPoint Standard Indoor
10/100
Power 10-28 VDC, PoE
MAC ID Ethernet 0040840AF33E
MAC ID Wi-fi 00408-IOAF33F
Manufactured: 2009.07.13 MADE IN CHINA
4 4 4 1 1
3 3 3 2 2
2 2 2 3 3
1 1 1 4 4
CLIP SQUARE
FERRITE CLIP TO
THE PIGTAIL
PLUG RJ45
CONNECTOR (IF
REQD.) IN THE RJ45
TERMINAL PLUG
PUSH THE 9 AND 10-PIN MOLEX TERMINALS
FIRMLY INTO THE READER PORTS J9 AND J10
RESPECTIVELY. ENSURE THAT ALL 9 AND 10
PINS GO INSIDE THE HOLES OF THEIR
RESPECTIVE TERMINALS AND THAT THE
SPECIAL PROTRUSIONS ON THE TERMINALS
MATE WITH THE SPECIAL SLOTS PROVIDED MATE WITH THE SPECIAL SLOTS PROVIDED
ON THE PORTS. THIS ENSURES THAT THE
TERMINALS CANNOT BE PLUGGED INTO
WRONG PORTS.
Fig. 7. Plugging the connectors into the IdentIPoint reader
PIN 1
PORT
J10
PIN 10
TO PIN 10
TO PIN 1
10-PIN MOLEX
TERMINAL
UG
BOTH MOLEX TERMINALS
SHOULD FIT FIRMLY INSIDE
THEIR RESPECTIVE PORTS
AT THE BACK OF THE AT THE BACK OF THE
READER AS SHOWN
8