Ip Address Pool-Level Thresholds; Configuring Ip Address Pool-Level Thresholds - Cisco ASR 5000 Series Thresholding Configuration Manual

IP Pool Utilization Thresholds

IP Address Pool-Level Thresholds

This section provides instructions for configuring a single IP address pool utilization threshold for all pool groups within
the context.
Important:
command take precedence over the context level IP pool threshold configuration commands.
Important:
If the group-available threshold is set for individual IP pools that are a part of an IP pool group, the IP pool with the
threshold that is encountered first sets the threshold for the entire group.
For example; assume there is a group named
. Also assume that, at the IP address-pool level, the three pools have the group-available threshold set as follows:
PoolC
PoolA:
PoolB:
PoolC:
In this case, the Enter condition for the percentage of IP pool addresses available from the group that is encountered first
is the low threshold setting for PoolA. So both the low and high threshold settings for PoolA are used for the whole
group.

Configuring IP Address Pool-Level Thresholds

configure
threshold poll { available-ip-pool-group | ip-pool-free | ip-pool-hold | ip-pool-
release | ip-pool-used } interval <time>
context
ip pool name alert-threshold group-available <low_thresh> [ clear <high_thresh> ]
ip pool name alert-threshold pool-free <low_thresh> [ clear
ip pool name alert-threshold pool-hold <high_thresh> [ clear <low_thresh> ]
ip pool name alert-threshold pool-release <high_thresh> [ clear <low_thresh>]
OL-25552-02
The IP pool-level threshold settings configured with the
These instructions also assume that IP address pools have been previously configured.
Enter condition (low threshold) set to 40 percent
Clear condition (high threshold) set to 60 percent
Enter condition (low threshold) set to 30 percent
Clear condition (high threshold) set to 70 percent
Enter condition (low threshold) set to 20 percent
Clear condition (high threshold) set to 50 percent
<context_name>
, and there are three IP pools in that group;
IPGroup1
Cisco ASR 5000 Series Thresholding Configuration Guide ▄
IP Address Pool-Level Thresholds ▀
ip pool pool_name alert-threshold
PoolA
<high_thresh> ]
, , and
PoolB
85