Configuring Fng Thresholds - Cisco ASR 5000 Series Thresholding Configuration Manual

▀ Configuring FNG Thresholds

Configuring FNG Thresholds
Use the following configuration example to configure FNG threshold monitoring:
configure
[ no | default ] threshold monitoring fng-service
[ default ] threshold fng-current-sessions <high_thresh> [ clear <low_thresh> ]
[ default ] threshold poll fng-current-sessions interval <time>
end
Usage thresholds are provided for monitoring the overall FNG usage on an ASR 5000 chassis. These commands are
used to monitor the total number of FNG sessions, both active and inactive, over an entire chassis.
In the commands above,
active and inactive.
threshold monitoring.
The
clear <low_thresh>
<high_thresh>
The following example configures a monitoring threshold of 300000 active and inactive FNG sessions on an ASR 5000
chassis:
threshold fng-current-sessions 300000
This turns out to be too many, so the following command clears 100000:
threshold fng-current-sessions 300000 clear 100000
▄ Cisco ASR 5000 Series Thresholding Configuration Guide
74
configures the total number of FNG sessions on an ASR 5000 chassis, both
<high_thresh>
is any integer from 0 to 300000. There is no default, but 0 means that there is no
<high_thresh>
command clears any percentage of the number of sessions being monitored using the
variable defined above.
<low_thresh>
is any integer from 0 to 300000.
FNG Thresholds
OL-25552-02