Assembly - Grizzly G0791 Owner's Manual

Assembly

Assembling the Model G0791 consists of build-
ing the stand assembly, attaching the handwheel
handles, placing and securing the lathe on the
stand, anchoring the stand to the floor, attaching
the back splash, and installing the drawbar.
To assemble machine:
1.
Position left and right cabinets approximately
34" apart in prepared location.
2.
Secure front panel brackets to cabinets with
(4) M6-1 x 10 Phillips head screws and (4)
6mm flat washers (see Figure 11).
Brackets
Cabinets
Figure 11. Brackets installed (rear view).
-22-
x 4
3. Remove crate from lathe shipping pallet, then
remove all loose items.
Important: Lifting and placing the lathe
requires at least one other person for assis-
tance and a forklift with two lifting straps, lift-
ing chain, and a safety hook rated for at least
2000 lbs. each.
4. Move lathe to its prepared location while it is
still attached to shipping pallet.
5.
Unbolt lathe from shipping pallet.
6.
Attach handles to cross slide and carriage
handwheels (see Figure 12).
Handwheel
Handles
Figure 12. Handwheel handles attached.
7. To balance load for lifting, move tailstock and
carriage to right end of bedway, then lock
them in place.
Note: Before attempting to move the carriage,
make sure the carriage lock is loose, the half
nut is disengaged, and the feed selection
lever is disengaged. Refer to Controls &
Components, beginning on Page 5, to iden-
tify these components.
Model G0791 (Mfd. Since 9/15)