Assembly - Grizzly G0842 Owner's Manual

Assembly

the machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. to ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble lathe:
1.
attach (4) legs to tool tray with (8) M8-1.25 x
16 carriage bolts, (8) 8mm flat washers, and
(8) M8-1.25 hex nuts (see figure 13). Finger-
tighten hex nuts for now.
Note: Leg with warning label attaches to front
left corner of tool tray; flanged side of tray
faces up.
Tip: Fasten legs to tool tray over a clean
piece of cardboard on floor to avoid scratch-
ing paint.
Warning
label
Flange
Facing up
x 8
figure 13. legs attached to tool tray.
-18-
tool tray
legs
2. position end supports between tops of legs
and attach each support with (6) M8-1.25 x
16 carriage bolts, (6) 8mm flat washers, and
(6) M8-1.25 hex nuts (see figure 14). Finger-
tighten hex nuts for now.
x 12
figure 14. End supports installed onto legs.
3.
With help of an assistant, lift lathe and align
mounting holes in bottom of lathe with holes
in tops of end supports (see figure 15).
4. attach lathe to end supports with (8) M8-1.25
x 16 hex bolts, (8) 8mm lock washers, and (8)
M8-1.25 hex nuts (see figure 15).
(Headstock End)
figure 15. lathe attached to end supports.
Model G0842 (Mfd. Since 04/18)
End
Supports
(Tailstock End)
x 8