Assembly - Grizzly G0949G Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble lathe:
1.
Position left and right cabinets approximately
36½" apart in prepared location.
2.
Secure panel brackets to cabinets with (4)
M6-1 x 12 cap screws, 6mm lock washers,
and 6mm flat washers (see Figure 14).
Brackets
Cabinets
Figure 14. Panel brackets installed (rear view).
3. Install front panel onto panel brackets with (4)
M6-1 x 12 cap screws, (8) 6mm flat washers,
(4) 6mm lock washers, and (4) M6-1 hex nuts
(see Figure 15).
Front Panel
Figure 15. Front panel installed.
-22-
x 4
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
IMPORTANT: During the following steps, DO
NOT attempt to lift or move this lathe without
using the proper lifting equipment (such as fork-
lift or crane) and the necessary assistance from
other people. Each piece of lifting equipment must
be rated for at least 1000 lbs. to support dynamic
loads that may be applied while lifting.
4. Using a forklift, move crate to machine work
site location.
5. Remove crate top and sides, components
inside crate, and blocks around machine
base.
6. Unbolt lathe from shipping pallet.
7.
Thread handles into carriage and cross slide
handwheels, as shown in Figure 16.
Figure 16. Handwheels installed.
Model G0949G (Mfd. Since 01/22)
HEAVY LIFT!
Cross Slide
Handle
Carriage
Handle