Section 5: Mill Operations; Operation Overview - Grizzly G0791 Owner's Manual

SECTION 5: MILL OPERATIONS

Operation Overview

To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and face shield when operating this
machine.
-64-
To reduce risk of injury and increase
longevity of machine, always start spindle
rotation with spindle speed dial set to low-
est setting.
To complete a typical operation, the operator
does the following:
1.
Examines workpiece to make sure it is suit-
able for cutting.
2.
Securely clamps workpiece to table.
3.
With machine disconnected from power,
installs correct cutting tool.
4.
Adjusts headstock height above table.
5.
Checks range of table or spindle movement
necessary for operation to make sure setup is
safe and correct.
6.
Selects correct spindle speed and rotation
direction.
7.
Puts on required safety glasses and face
shield.
8. Connects machine to power and turns it ON.
9. Uses downfeed controls or cross slide table
controls to perform cutting operation.
10. Turns machine OFF and waits for spindle to
completely stop before removing workpiece.
Model G0791 (Mfd. Since 9/15)