Assembly - Grizzly G0835 Manual

Assembly

Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Assembling the G0799 & G0800 lathes consists
of attaching the legs to the lathe bed, and then
attaching the chuck guard, tool rack, chisel pan,
and swing-away bed.
To assemble lathe:
1. Position stand legs upright approximately
48 ⁄ " apart, and align them reasonably well
1
4
(see Figure 14).
Figure 14. Stand legs aligned and correctly
positioned 48
-22-
HEAVY LIFT!
48 ⁄ "
1
4
⁄ " apart.
1
4
2. Insert chisel pan mounting rod into two brack-
ets underneath chisel pan (see Figure 15).
3. Install (1) M12-1.75 hex nut and (1) 12mm flat
washer on each end of mounting rod, then
insert into designated hole on each leg (see
Figures 15–16) and loosely secure with (2)
M12-1.75 lock nuts and 12mm flat washers.
x 2
Mounting
Brackets
(1 of 2)
Figure 15. Chisel pan components installed on
stand.
Hex Nut &
Flat Washer
Figure 16. Chisel pan hex nut and flat washer
installed.
Note: The lock nuts on the chisel pan mount-
ing rod should not be tightened until the lathe
bedway has been installed.
Model G0799 G0800 (Mfd. Since 11/17)
Chisel Pan
Mounting
Rod