Removing Compound Rest - Grizzly G0791 Owner's Manual

Removing
Compound Rest
The compound rest and tool post must be removed
before milling operations so the cross-slide table
can be used as the milling table.
Tool Needed
Open-End Wrench 14mm .................................. 1

Removing Compound Rest

1. Loosen both hex nuts shown in Figure 97,
then slide T-bolt out of first compound rest
slot.
Figure 97. Location of compound rest hex nuts
and flat washers.
2. Remove compound rest, then remove
second T-bolt from rear T-slot in cross-slide
table (see Figure 98).
Cross Slide
Table
Figure 98. Compound rest and T-bolts removed.
Model G0791 (Mfd. Since 9/15)
Re-installing Compound Rest
1.
Qty
2.
3.
x 2
T-Slots
With T-Bolts
Removed
Re-install one T-bolt, with flat washer and hex
nut, into rear T-slot, as shown in Figure 99.
x 1
Figure 99. T-Bolt installed in rear T-slot.
Align compound rest with cross slide table,
and insert T-bolt from Step 1 into rear slot of
compound rest.
Re-install second T-bolt with flat washer and
hex nut into T-slot and front slot of compound
rest, slide compound rest to desired position,
then tighten both hex nuts (see Figure 100).
Front Slot
T-Slot
Figure 100. Compound rest installed.
x 1
-65-