8680i Is Out of Range
The 8680i is in communication with its host, even when it is not transmitting bar
code data. Whenever the 8680i can't communicate with the host for a few seconds,
it is out of range. If the 8680i is out of range and you scan a bar code, the 8680i
issues an error tone indicating that there was no communication with the host.
Refer to
8680i Is Moved Back Into Range
The 8680i relinks if the 8680i or the host have been reset, or the 8680i comes back
into range. If the 8680i relinks, you will hear a single chirp when the relinking pro-
cess (uploading of the parameter table) is complete. Refer to
on page 28 and
Reset Scanner
Scanning this bar code reboots the 8680i and causes it to relink with the host.
Scanner Report
Scan the bar code below to generate a report for the connected 8680is. The report
indicates the port, 8680i name, and address. To assign a name to your 8680i, refer
to
Scanner Address
Scan the bar code below to determine the address of the 8680i you are using.
8680i User Guide
Out-of-Range
Auto Reconnect
Device
Name, page 37.
Alarm, page 28 and
Mode, page 24 for further information.
Reset Scanner
Scanner Report
Scanner Address
Auto Reconnect
Mode, page 24.
Out-of-Range Alarm
27