Honeywell 8680i User Manual page 110

Codabar Concatenation
Codabar supports symbol concatenation. When you enable concatenation, the
8680i looks for a Codabar symbol having a "D" start character, adjacent to a sym-
bol having a "D" stop character. In this case the two messages are concatenated
into one with the "D" characters omitted.
Select Require to prevent the 8680i from decoding a single "D" Codabar symbol
without its companion. This selection has no effect on Codabar symbols without
Stop/Start D characters.
Codabar Redundancy
If you are encountering errors when reading Codabar bar codes, you may want to
adjust the redundancy count. Redundancy adjusts the number of times a bar code
is decoded before transmission, which may reduce the number of errors. Note that
the higher the redundancy count, the longer it will take to decode the bar code. To
adjust the redundancy, scan the Codabar Redundancy bar code below, then scan a
redundancy count between 0 and 10 on the
page 235. Then scan the Save bar code. Default = 0.
96
On
Require
A 1 2 3 4 D D 5 6 7 8 A
Programming Chart,
Codabar Redundancy
* Off
beginning on
8680i User Guide