Illumination Lights; Aimer Delay - Honeywell 8680i User Manual

ness is decreased, making it less aggressive when reading good quality bar codes.
This setting does not affect 1D bar code reading. Default = Poor Quality PDF Read-
ing Off.
Poor Quality PDF Reading On

Illumination Lights

If you want the illumination lights on while reading a bar code, scan the Lights On
bar code, below. However, if you want to turn just the lights off, scan the Lights Off
bar code. Default = Lights On.
Note: This setting does not affect the aimer light. The aiming light can be set using
Mode

Aimer Delay

The aimer delay allows a delay time for the operator to aim the 8680i before the
image is taken. Use these codes to set the time between when the trigger is pressed
and when the image is taken. During the delay time, the aiming light appears, but
the LEDs won't turn on until the delay time is over. Default = Off.
8680i User Guide
(page 50).
* Lights On
200 milliseconds
* Poor Quality PDF Reading
Off
Aimer
Lights Off
400 milliseconds
49