Menu Bar Code Security Settings; Set Custom Defaults - Honeywell 8680i User Manual

5. Use the information shown for the IPv4 address, the IPv4 DNS servers, and the
Note: The TCP Port is always 3390.
6. Click on either Create 1D Wifi Bar Code or Create 2D Wifi Bar Code.
7. Print the bar code and scan it with the 8680i to connect to the WiFi network.

Menu Bar Code Security Settings

Honeywell scanners are programmed by scanning menu bar codes or by sending
serial commands to the 8680i. If you want to restrict the ability to scan menu
codes, you can use the Menu Bar Code Security settings. Please contact the near-
est technical support office (see
mation.

Set Custom Defaults

You have the ability to create a set of menu commands as your own, custom
defaults. To do so, scan the Set Custom Defaults bar code below before scanning
the menu commands for your custom defaults. If a menu command requires scan-
ning numeric codes from the
sequence is saved to your custom defaults. When you have entered all the com-
mands you want to save for your custom defaults, scan the Save Custom Defaults
bar code.
Note: Scanning the Save Defaults bar code also causes both the 8680i and the host to
perform a reset and become unlinked. You must relink (pair) the 8680i to the host.
You may have a series of custom settings and want to correct a single setting. To do
so, just scan the new setting to overwrite the old one. For example, if you had previ-
ously saved the setting for Beeper Volume at Low to your custom defaults, and
decide you want the beeper volume set to High, just scan the Set Custom Defaults
bar code, then scan the Beeper Volume High menu code, and then Save Custom
Defaults. The rest of the custom defaults remain, but the beeper volume setting is
updated.
8680i User Guide
network name to fill in the EConfig screen.
Set Custom Defaults
Technical Assistance
Programming Chart, then a Save code, that entire
on page iii) for further infor-
Save Custom Defaults
21